Make sure to use the correct VI for Nissan Diagnostic Tool C-III plus (plus VI).ĬAUTION: Make sure the plus VI is securly connected. The abve conditions are required for the IAVL to complete.ġ.Connect the plus Vehicle Interface (plus VI) to the vehicle.
After reprogramming is complete, you will be required to perform Throttle Valve Closed Position, Idle Air Volume Learn (IAVL), Accelerator Closed Position, and DTC erase.Ģ. Hybrid only: Li-ion battery charging status: 50% or moreĮngine coolant temperature: 70 – 100☌ (158 – 212☏)īattery voltage: More than 12.9V (At idle)ġ. O If there are any DTCs other than those listed in the accompanying Symptom based TSB, diagnose, perform repairs, and erase DTCs before continuing.įor conventional and hybrid vehicles if reprogramming the ECM, take the vehicle for a 10 minute drive in order to meet the following conditions: O Use C-III plus to perform Self Diagnosis for all systems.
#NISSAN CONSULT SOFTWARE DOWNLOAD PC#
* A screen print for Warranty documentation can be done from the CONSULT PC during this process while still connected to the vehicle.
NOTE: The CONSULT PC automatically gets applicable ECM and TCM reprogramming data during ASIST synchronization. * All C-III plus software updates (if any) have been installed.
* ASIST on the CONSULT PC has been freshly synchronized (updated).
#NISSAN CONSULT SOFTWARE DOWNLOAD HOW TO#
How to Install Nissan Consult 3 III Plus Diagnostic Software Note:A symptom based TSB isrequired before using this procedure.This procedure does not apply to Nissan LEAF?. This article show a guide on how to use Nissan Consult3 Plus to reprogram Engine Control Module(ECM) or Transmission Control Module (TCM).
0 kommentar(er)
